Should be shipped like this, or be an option when ordering. But that means opening up, turning the fans around. Issue is present since the first prototypes, if I can believe the reviewsĤ) the internal filtering is useless, you really have to mount the extraction tube. Clearly this needs a redesign to prevent the screws from loosening. Also had more parts than needed (for other engravers) so it was a puzzleģ) all belts were loose, the screws to fasten them were not fixed at all. I had some minor, non-obvious issues to install, including the laserhead mount tubes sliding too far and blocking the air. Support was quick to send a FW update to reflashĢ) the air-assist came with no installation doc, there is none online except a 40 second video. Half of the issues were mentioned in reviews of 6+ months ago so they could have been solved, OTOH the reviews made me know about it and the fixes were easy.ĭon't get me wrong, it is a nice machine and works well, I included the air support, got some Dry Molly, and results are very nice!īut, yes, there is room for improvement, TwoTrees:ġ) the included programs are old, the config file was even for a previous iteration of the TS3 that had the Y axis mirrored. So far I have enjoyed the TS3 after a bit of a bumpy start.
